Application
| HTM140 is te vergelijken met het RCP30 Nano Cure, echter HTM140 heeft zonder nabehandeling al direct na het 3D printen een HTD van 140°C. Er kan een zeer hoge detaillering worden bereikt. Enkele toepassingen: |
| Gietmatrijsjes voor bijv. rubber |
| Testonderdelen te gebruiken in hete lucht of heet water |
| Testonderdelen voor windtunnels |
| Diverse toepassingen voor de electronica |
Building Resolutions HTM140
| Oppervlak tot |
16μm |
| Laagdikte min. |
25μm |
Classification HTM140
| Type |
Photopolymer |
| Colour |
Olive green |
| Classification |
N.A. |
Eigenschappen HTM140
| Properties |
Units |
Method |
Value |
| Density |
[G / cm ³] |
DIN ISO 1183-1 |
|
| Tensile Strength |
[MPa] |
DIN EN ISO 527-1 |
56 |
| Elongation at Break |
% |
DIN EN ISO 527-1 |
3.5 |
| Flexural Strength |
[MPa] |
DIN EN ISO 178 |
115 |
| Flexural Modulus |
[MPa] |
DIN EN ISO 178 |
3350 |
| Heat Deflection Temp. (HDT) zonder thermische behandeling |
° C |
ASTM D 648 |
140 |
2012-01-17: added.
All data provided herein, which is related to consumables, was collected from specific specimens and tests conditions and is provided for information only. Characteristics may vary if different specimens and test conditions are applied. Unless expressly provided in writing, no warranties are made and warranties of merchantability or fitness for a particular purpose are expressly disclaimed. All data provided is preliminary and must be verified by the individual user.
